Configuration¶
Firmware Specific¶
Once you have LedFx installed, it’s time to add some devices! Make sure you have a device with appropriate firmware for integration with LedFx. Open the LedFx UI and navigate to the ‘Device Management’ page. Click the “Add Device” button at the top right of the web page. Add the device using the following configuration based on your firmware:
Add the device as an E1.31 device.
The default E1.31 settings should work fine.
Scott’s Audio Reactive Firmware
Add the device as a UDP device.
Click ‘Additional Properties’ and check the ‘Include Indexes’ box.
- Add WLED as UDP device
Enter the name for your device and IP address
Enter 21324 for the port
Enter the total number of pixels
Click “Show More” and enter 0201 for “Data Prefix”
Click Submit
- Add WLED as E1.31 device
Enable E1.31 support from the ‘Sync Settings’ page on the WLED web-interface and reboot WLED
Enter the name and IP address
Enter the total number of pixels
Click Submit